Home > Articles > Cisco > CCIE

  • Print
  • + Share This
This chapter is from the book

Section 9: Multicast (4 Points)

  • Enable your network to allow hosts on VLAN4 to receive and send multicast traffic from and to VLAN2; only perform configuration on R5 and R6 using PIM sparse dense mode.

  • Configure R6 to respond to pings from R5 to the multicast address of 224.4.4.4.

  • Do not allow R5 to fully participate in the PIM process by not allowing it to become a neighbor, but do allow any IGMP messages generated by hosts on VLAN4 to be received by R6.

  • + Share This
  • 🔖 Save To Your Account